Installing additional products
Once you have successfully installed OpenEdge, you can elect to add additional products to your current installation.
To initiate this process, you must re-load your installation media. Perform the steps outlined in "Loading the installation media" section and then perform the steps outlined below in this section.
Note: When you add products to an existing installation, you can use the Installation Utility in batch mode as long as you are performing a Complete installation of the products you are adding. For more information about a batch installation, see the "Running the installation in batch mode" section.
|
To install additional products when the Welcome dialog box appears: |
- Press RETURN to continue. The Serial & Control Numbers dialog box appears.
- Enter only the control numbers for the products you are adding to the list of previously installed products.
- When you are done, press CTRL+E. The Done Configuration Data Confirmation dialog box appears.
- Press Y to continue (or press N to add more products). The Type Device and Destination dialog box appears.
- Choose Select the Destination Pathname, and type the path of the initial installation.
- Press RETURN. The Destination Pathname Exists dialog box appears:
- Choose Install the OpenEdge products in the pre-existing destination path and press RETURN to continue with the installation.
- Choose Yes to continue with the installation.
If you install products that affect your previously installed products, you might see the following caution message:
The installation program adds your OpenEdge products to your directories automatically.